Adjust Software to Optimize Image
Unless otherwise indicated, instructions apply to all projector models in stand-alone or
multi-projector configurations.
1. Display an external signal.
2. Select Screen Image Orientation in
Configuration > Output Options and
change the orientation of the displayed
image to suit the installation.
3. Assign projector ID number(s). See
Projector Address
4. Make sure that ArrayLOC is enabled. From
the Main menu select ArrayLOC and select Enabled from the Bright/ColorLOC Mode drop-
down list. ArrayLOC automatically adjusts projector colors and brightness.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
on page 62.
Setup Procedures
23