Christie Matrix StIM-WQ User Manual page 100

Serial Command Reference
ABL
ALBV
DEVC
WENA
WBTH
WGTH
IRTG
SKEY
SFRD
AFRD
AFRS
SRGB
SACF
SCLE
88
When set, all projectors in brightness group will use this
projectors settings:
0 = OFF (normal)
1 = synchronize to group
Note: A group can synchronize to only one projector. Setting
ABL+ABLV on any projector in a group to make that projector
the master projector releases the setting from any previous
master projector in the group.
Specifies the ethernet port used for transfer of ColorLOC data.
When selected will use the Control Network port rather than
default ArrayLOC Network port.
0 = ArrayLOC network
1 = Control network
(FUTURE USE).
Enable warnings associated with Bright/ColorLOC.
0 = disable
1 = enable
(FUTURE USE). Sets the brightness threshold at which a
warning is issued when warnings are enabled. (0-100 percent).
(FUTURE USE). Sets the gamut threshold at which a warning is
issued when warnings are enabled (0-100 percent).
(FUTURE USE). IR Brightness Target. Sets the target brightness
that the projectors in the array brightness group should meet.
(Rang is 0-1000).
Synchronize remote control keystrokes, test pattern and color
enable amongst array projectors 
0 = Independent 
1 = Synchronized
Synchronize frame delay amongst array projectors 
0 = Independent 
1 = Synchronized
Sets the array frame delay parameter. Applies to all projectors
in array if SFRD is set to Synchronized
Read-only control reports smallest frame delay value in array
that will not generate tearing artifacts
Synchronize RGB Brightness setting amongst array projectors.
0 = Independent 
1 = Synchronized
Synchronize AccuFrame setting amongst array projectors.
0 = Independent 
1 = Synchronized
Synchronize Color Enable setting amongst array projectors.
0 = Independent
1 = Synchronized
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)