ArrayLOC Network Configuration
Preliminary color setup is managed by ArrayLOC. ArrayLOC is enabled by default and configured to
display a reasonably saturated gamut at the maximum brightness that all the projectors in the array
can support. See
Configure the Display
A projector that is not connected via ArrayLOC functions as a single unit array.
ArrayLOC over Control Network
Use the Control Network for ArrayLOC when you want to communicate with the projectors in the
array over the same network.
1. Connect the controller by connecting a CAT 5 Ethernet cable between the PC and the ArrayLOC
network switch.
2. Connect a standard CAT5 Ethernet cable between the ArrayLOC network switch and the Control
Network port of each projector.
3. From the Main menu, select ArrayLOC > ArrayLOC Configuration.
4. From the ArrayLOC Network drop-down list select Control Network.
The length of the connections depends on ArrayLOC network switch placement within the
array. It may be possible to reuse the Ethernet cable supplied with the projector for one of
these connections, but at least one connection requires that you supply an additional
Ethernet cable per projector.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
on page 59 for detailed information.
CAT5
CAT5
ArrayLOC
Network Switch
CAT5
CAT5
CAT5
CAT5
CAT5
CAT5
Setup Procedures
19