Serial Flow Control (Flw); Frame Delay (Frd) - Christie Matrix StIM-WQ User Manual

Serial Command Reference

Serial Flow Control (FLW)

FLW
Preference
CONTROL GROUP:
Description
Set the flow control for a serial communications port.
Subcode
PRTA
PRTB
PRTC
Examples:
(FLW+PRTA 0) Set no flow control on port A. 
(FLW+PRTA 1) Set flow control on port A to software. 
(FLW+PRTA?) Get flow control (FLW+PRTA!001 "Software")

Frame Delay (FRD)

FRD
Preference
CONTROL GROUP:
Description
Delays the output signal timing relative to the Input signal timing by a fraction of a frame, and up to 1 frame. 
The value used is a 1/1000th of a frame. For example, 1000 equals 1 frame.
Frame Lock Enable (FLE)
See
Subcode
STAT?
Examples:
(FRD 500) Delay 0.5 frames. 
(FRD+STAT?) Retrieve actual minimum frame delay.
98
Power Down
SUBCLASS:
Description of Use
Set the mode on port A (RS-232 IN)
Set the mode on port B (RS-232 OUT)
Set the mode on port C (RS-422)
Power Up
SUBCLASS:
on page 97.
Description of Use
Retrieve the actual minimum frame delay.
Advanced
ACCESS LEVEL:
.
Operator
ACCESS LEVEL:
Matrix StIM™ WQ/SIM WQ User Manual
.
.
020-100883-01 Rev. 2 (06-2013)