Configure The Display; Output Options; Change Screen Image Orientation; Control Frame Locking - Christie Matrix StIM-WQ User Manual

Configure the Display

The Configuration menu provides access to diagnostics,
calibration tools and the Service submenu (password-
protected). Use this menu to define general operating
parameters and communications with other projectors and
equipment, and to access other advanced processing and
image adjustments affecting overall performance. To access
this menu select Configuration from the Main menu.

Output Options

Change Screen Image Orientation

1. From the Main menu, select Configuration >
Output Options.
2. From the Screen Image Orientation drop-
down select from front, rear, front inverted,
and rear inverted.

Control Frame Locking

Use frame locking to select how the projector controls the output frame timing based on the input
signal.
Frame locking on projectors in a ArrayLOC network can be controlled from 1 projector. 
See
1. From the Main menu, select Configuration > Output Options.
2. From the Frame Locking drop-down menu select Frame Lock to lock output image frames to
the primary input or select Frame Lock Secondary to lock output images to the secondary
input.

Set Frame Delay

This control delays the output signal timing relative to the input signal timing by a fraction of a
frame. In a multi-projector system this control may be used to adjust the output timing relative to
the input so that all the projectors display the image at the same time. This allows for a seamless
display across projectors.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
Configure the Display
on page 59.
Configure the Display
59