Connect The Cinema Projector To Ac Power With A Pluggable Type B Connection; Configure The Optional Uninterrupted Power Supply - Christie CP2220 User Manual

Section 2: Installation and Setup
2.14 Connect the Cinema Projector to AC Power with a Pluggable Type B Con-
nection
When connecting the cinema projector to AC power, follow all electrical codes for your location. In addition,
follow these recommendations:
• There must be easy access to the current protection device or breaker in the building.
• Use 10AWG or 8AWG wiring: the distance between the wall circuit breaker and the cinema projector must
not exceed 20 meters using 10AWG cables or 30 meters using 8AWG cables.
• The socket-outlet is installed near the equipment and is easily accessible.
• The plug can be used as the device disconnect and is near the unit and easily accessible.
1. On the bottom of the cinema projector in the front right corner, loosen the 2 screws and slide the plate
forward to expose the terminal block.
2. Remove the 4 knockout plate screws located in the bottom right corner of the front bezel.
3. Connect AC power to the terminal block, beginning with the ground lead first. Tighten the screws securely.
4. Replace the knockout plate and the bottom access panel over the terminal block.

2.15 Configure the Optional Uninterrupted Power Supply

A UPS allows the cinema projector electronics to remain operable during a power failure.
2-12 CP2220 User Manual
020-100420-08 Rev.1 (5-2014)