Install And Configure The Christie Imb - Christie IMB User Manual

Install and Configure the Christie IMB

The Christie Integrated Media Block (IMB) is installed in the card cage located on the operator side of
the projector. The part number for the Christie IMB is 108-384107-XX.
Administrator permissions are required to access the Administrator Setup menu.
To prevent damage by static electricity, keep the Christie IMB in its anti-static package until
you install it. When installing the Christie IMB, wear an anti-static wrist strap and follow
anti-static protocols.
1. Turn the lamp off and allow the projector to cool a minimum of 15 minutes.
2. Disconnect AC power from the projector.
3. Remove the top cover:
a. Unlock the cover with the low security key.
b. Remove the lid and set it aside.
4. Remove the high security cover:
a. Unlock the high security cover with the high security key.
b. Remove the cover and set it aside.
5. Remove the card cage cover:
a. Push down on the tab on the top of the cover.
b. Lift the cover up as you move it away from the projector.
c. Remove the cover and set it aside.
Christie Integrated Media Block User Manual
020-100845-05 Rev. 1 (08-2013)
Hardware Installation and Setup
5