Arrayloc; Cannot Find Color Adjustment Controls; Color/Image Settings Are Greyed Out; Sensor Isn't Calibrated (Yellow Alert) - Christie Entero RPMWU-LED01 Service Manual

Section 3: Troubleshooting
3.8

ArrayLOC

3.8.1 Cannot Find Color Adjustment Controls

Use the color adjustment options under the ArrayLOC menu: Main Menu > Configuration > ArrayLOC.
Color adjustments by X,Y and color saturation options are not available for general use; they are part of the
pass code protected service menu.

3.8.2 Color/Image Settings Are Greyed Out

To enable ArrayLOC:
• Main Menu > Configuration > ArrayLOC > Bright/ColorLOC Mode
• Set to Fixed, Cool, or Bright.
If ArrayLOC is enabled:
• ArrayLOC handles brightness and color settings, and will override other color settings.
• Main menu > Configuration > ArrayLOC > Array Color Target
NOTE: Color settings are available for the master projector and are greyed out for all other projectors.
To make your projector the master:
• Main menu > Configuration > ArrayLOC > Synchronize to This Projector
NOTE: Any projector in the array or BC group can be the master. The last projector to be set as the master
is the master for the array (All) or BC group (Group). This setting is saved between session.

3.8.3 Sensor Isn't Calibrated (yellow alert)

Sensor calibration must be performed by Christie accredited service technicians. Contact customer support.

3.8.4 Invalid Target Gamut (yellow alert)

A color setting is not valid for the current color space, for example a white point is outside of the gamut.
• Main Menu > Configuration > ArrayLOC > Array Color Target
• Check XY settings for the colors.

3.8.5 Unable to Achieve Target Brightness/Gamut (yellow alert)

A projector in an array that cannot achieve minimum brightness or target color space will disable BCLOC and
cease contributing data to performance calculations.
• Lower the target brightness or color gamut settings until all the projectors can achieve the same performance.
• If the discrepancy is too big, the light module may need to be replaced. Call Customer Support.
3-8 Entero RPMSP/RPMWU/RPMHD-LED01 Service Manual
020-100368-05 Rev. 1 (06-2012)