Analog Audio Destination Port Properties Window; Device Properties Windows; Transmitter Mode - Lightware UBEX Series User Manual

 
     
8. Lightware Device Controller 8. Lightware Device Controller
8.10.3. Analog Audio Destination Port Properties Window
Clicking on an analog audio destination port the properties panel opens on the right side. Clicking on the
icon the properties section opens in new window.

Analog audio destination port properties window

The most important signal information is available on the panel.
Settings and Tools
▪ Stream naming;
▪ Enabled: when it is checked in, the stream is transmitted to the receiver; if it is not, the stream is muted.
▪ Disconnect stream: clicking on the button results the source stream is disconnected from the output
port.
▪ Tags: unique and configurable tags can be attached to the stream for the best identification. The tags
are searchable in the Search Field.
▪ Volume: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the icon results +1% in the volume setting. The default value is 100%.
 
▪ Balance: sets the balance between -100 (total left) and 100 (total right). Clicking on the
-1, the icon results +1 in the balance setting. The default value is 0 (center).

▪ Mute: enable or disable the muting of the output port.
Identify unit: Clicking on the button makes the four front panel LEDs blink in green for 10 seconds. The
▪
feature helps to identify the device itself in the rack shelf or on the desk.
▪ Device properties: Clicking on the button opens the properties windows of the endpoint device.
▪ Restart unit: clicking on the button makes rebooting the device (the same as disconnecting from the
power source and reconnecting again).
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
#analogaudio #volume #balance #gain
icon results

#mute #unmute
8.11. Device Properties Windows
8.11.1. Transmitter Mode
HDMI Input Ports
Clicking on the HDMI input 1 or 2 port icon results opens the Port properties. The most important signal
information and settings are available from the panel.
Endpoint tab of the Device properties window - Transmitter - Input port properties
Available Settings and Tools
▪ HDCP setting (Enable / Disable); #hdcp
▪ Frame Detector - The tool displays the frame information of the original stream coming from the input
port before a possible rescaling / frame rate conversion.
79 79