Corporate Application - Lightware UBEX Series User Manual

 
     
1. Introduction 1. Introduction
1.6.2. Corporate Application
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
Application diagram of Matrix mode - Corporate application
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Description
The UBEX matrix has more endpoint devices which can be
UBEX-PRO20-HDMI-F100 and UBEX-PRO20-HDMI-F110
variously and they can be in transmitter, receiver, or transceiver
operation modes.
The matrix is supervised by the UBEX Matrix Management Unit (MMU)
which is controlled by a PC. All endpoint devices and the MMU are
connected to a 96-port 10G Layer 3 network switch.
The transmitters can be connected to a single laptop or a dual head
4K rack PC and transmitting two streams together.
The receivers can be connected to one or two sink devices belongs to
the required application.
The transceivers can be connected to a source and a sink device
together. The source stream is extended to another transceiver or
receiver, the destination stream which is received from another UBEX
extender is displayed on the sink device.
The transmitted HDMI streams can be a 4K UHD 60 Hz 4:4:4 and
a 4K UHD 30 Hz 4:4:4, or two 4K 60 Hz 4:2:2 in the case of the
transmitters.
Thanks to the 20G full-duplex SFP+ interface the transceiver has
no bandwidth limitation on the input and output sides either. The
transceivers are able to receive and transmit 2x 4K60 Hz 4:4:4 24 bit
streams.
15 15
models