R-Series Endpoints - Transceiver Operation Mode - Lightware UBEX Series User Manual

 
     
3. Installation 3. Installation
3.4.6. R-series Endpoints - Transceiver Operation Mode
2xMM-2xDUO and 2xSM-2xDUO
2xMM-QUAD and 2xSM-QUAD
2xSM-BiDi-DUO
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
HDMI in
HDMI out
Local HDMI out
Ethernet
Power
OPT DUO
OPT QUAD
OPT DUO
OPT QUAD
OPT BiDi DUO
WARNING!
User Ethernet is also transmitted over the fiber optical interface so be sure not to create
network loop!
INFO:
The HDMI input 1 port cannot accept AV signal when the device is configured as transceiver.
* You can find more information about the cabling between the switch the R-series endpoint devices in the
Connection between the Switch and R-series Endpoints
Connect the transceiver and the source device (e.g. PC) using the HDMI input 2
port by an HDMI cable.
Connect a sink device (e.g. monitor) to the HDMI output 1 port by an HDMI
cable.
Connect a local sink device (e.g. 4K TV) to the HDMI output 2 port by an
HDMI cable. The port transmit the original stream of the HDMI in 2 port.
Optionally connect the transceiver to a LAN in order to control the device.
Connect the power adaptor to the AC input on the transceiver first, then to
the AC power socket.
Connect the device and the L3 network switch by 2 pcs multimode Neutrik
opticalCON DUO or 4 pcs multimode LC fiber optical cables. *
Connect the device and the L3 network switch by a multimode Neutrik
opticalCON QUAD fiber optical cable. *
Connect the device and the L3 network switch by 2 pcs singlemode Neutrik
opticalCON DUO or 4 pcs singlemode LC fiber optical cables. *
Connect the device and the L3 network switch by a singlemode Neutrik
opticalCON QUAD fiber optical cable. *
Connect the device and the L3 network switch by a singlemode Neutrik
opticalCON DUO BiDi or 2 pcs singlemode LC fiber optical cables. * The
connector does not support the Neutrik opticalCON cross cable. Please use
standard cable only.
section.
32 32