Lightware UBEX Series User Manual page 180

 
     
13. Assembly Guides 13. Assembly Guides
Step 5. Remove the front plate from the chassis.
Step 6. Push out the four light pipes from the front plate starting from the
rear side of the plate.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Insertion of the New Front Plate
Step 1. Insert the four light pipes to the new front plate starting from the
front side of the plate. Take care of the direction of the light
pipes.
Step 2. Place the front plate to the chassis.
Step 3. Fasten all the six screws on the front plate using the PZ1
screwdriver.
Step 4. Insert the jog dial knob to the holder so that fixing screw hole shall
be over the flat part of the holder.
180 180