Lightware UBEX Series User Manual page 167

 
     
10. Firmware Upgrade 10. Firmware Upgrade
Step 3 - Set the IP Addresses of the Endpoint Devices.
Two possible methods are for completing it:
▪ via Lightware Device Controller (LDC) software;
▪ via using LW3 protocol commands.
Via LDC Software / Built-in Web
Connect to the MMU using one of the following methods:
▪ Launch the Lightware Device Controller (LDC) software and select the UBEX-MMU-X200 device in the
Device Discovery window. Connect to the MMU by clicking on the Connect button. See more details in
the Establishing Connection section.
▪ Open a web browser application and enter the IP address of the MMU. See more details in the
Control - Built-in Web chapter.
Select a source or destination stream in the crosspoint area to open the properties section in the right side.
Navigate to the Device tab and select the Device Properties button to open the device properties window.
Crosspoint menu - Port properties section - Device tab in the LDC software
A pop window opens with the device properties. Navigate to the Settings menu and select the Network tab. Set
the IP address of the endpoint device (static or dynamic (DHCP)).

ATTENTION! Always click on the Apply Changes button before closing the Device properties window.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Software
Device properties window - Settings menu - Network tab in the LDC software
ATTENTION!
Make sure that all endpoint devices have different static IP addresses or the dynamic IP address
(DHCP) is enabled in them to avoid the IP conflict.
Repeat the procedure with all endpoint devices which are wanted to be upgraded.
Via Using LW3 Protocol Commands
Connect to the MMU using a terminal application (e.g. Putty) or use the built-in Terminal of the LDC software
/ Built-in web. See more details in the
Type the following commands for enabling dynamic IP address (DHCP):
ç SET /MEDIA/DEVICEMAP/<logical_device_ID>/MNT/MANAGEMENT/NETWORK.DhcpEnabled=true
ç CALL /MEDIA/DEVICEMAP/<logical_device_ID>/MNT/MANAGEMENT/NETWORK:applySettings()
The <logical_device_ID>
Example:
ç SET /MEDIA/DEVICEMAP/X1/MNT/MANAGEMENT/NETWORK.DhcpEnabled=true
ç CALL /MEDIA/DEVICEMAP/X1/MNT/MANAGEMENT/NETWORK:applySettings()
Repeat the procedure with all endpoint devices which are wanted to be upgraded.
Terminal Window section.
is the ID of the endpoint device, for example: X1, X2, X3, etc.
167 167