Lightware UBEX Series User Manual page 81

 
     
8. Lightware Device Controller 8. Lightware Device Controller
Signal Info
All important information (resolution, pixel clock, color space, e.g.) are available in the signal info section.
The signal bandwidth and the bandwidth limit reached indicators can also be checked in this panel.
Related Audio Info
Information (presence, audio type, sampling frequency) of the embedded audio is available in the related
audio info section.
Tools
▪ Frame Detector - The tool displays the frame information of the original stream coming from the input
port before a possible rescaling / frame rate conversion.
SFP+ Link Panels
Clicking on the SFP+ Link 1 or 2 panel opens the properties of the SFP+ connections. The most important
signal information and the parameters of the SFP are available from the panel.
Link Aggregation Status Indicator
Icon
SFP+ connection is established successfully and the link aggregation is working
successfully.
No connection is established between the SFP+ links.
INFO:
You can find possible causes and solution suggestions in the
of no connection or link aggregation problems.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
#sfp
Description
Troubleshooting chapter in the case
Settings Menu
Clicking on the Settings menu opens the settings panel of the endpoint.
Settings tab of the Device properties window - Transmitter - Status tab
Status Tab
All important information are available about the transmitter, e.g. the MAC address of device, firmware
versions, system uptime, voltages, and temperatures.
Network Tab

ATTENTION! The network settings will be applied when the device is set to Extender mode. There is no
public IP address of the endpoint device when it is in Matrix mode.
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Factory defaults settings can be recalled with a dedicated button. See the factory default settings of the
endpoint device in the Factory Default Settings
#status #firmwareversion
section. #network #dhcp #ipaddress #mac
81 81