Lightware UBEX Series User Manual page 162

 
     
10. Firmware Upgrade 10. Firmware Upgrade
Upgrade Steps
Step 1. Select the firmware package.
Click on the Select Firmware Package button and navigate to the location where the LFP2 file of the MMU is
saved. When you click on the name of package, the preview of the release notes are displayed on the right
side.
Firmware file browser and the release notes window
After the package file is loaded, the list is filtered to show compatible devices only. The current firmware
version of the device is highlighted in orange if it is different from the version of the package loaded.
Filtered device list based on the selected firmware package
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Step 2. Select the unit for upgrading.
Pick the MMU(s) for upgrading. The selected line will be highlighted in green.
Step 3. Check the upgrade parameters.
ATTENTION!
The default settings in the Parameters
window should be fine for most cases. Please do not
modify them if it is not necessary.
Click on the Parameters button to configure the firmware
upgrade.
Backup Folder
Set the path of the device configuration backup file
which is created automatically. The default path is
USER_HOME/.ldu2/backup.
Restore Device Configuration
When it is enabled, the configuration settings of the
MMU will be restored after the upgrade. Enabled by
default.
Factory Default
If it is checked, all user settings and parameters will be cleared and the factory default settings will be
applied to the device when the upgrade is done. See the whole list of factory default settings of the MMU in
the UBEX-MMU-X200
Once the parameters are set, click on the Apply button to save the settings.
The unit is selected for upgrading
section.
162 162