Set The Audio Crosspoint State; Set The Parameters Of The Audio Streams - Lightware UBEX Series User Manual

 
     
3. Installation 3. Installation
3.9.14. Set the Audio Crosspoint State
Set up the audio crosspoint settings. Navigate to the Crosspoint menu and select the Audio layer. Digital and
analog audio source streams are also selectable in the case of UBEX-PRO20-HDMI-F110 endpoint device. All
audio streams can be selected to all outputs.
Audio crosspoint menu in the LDC
See more details about the audio crosspoint settings in LDC in the
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Crosspoint Menu - Audio Layer section.
3.9.15. Set the Parameters of the Audio Streams
Analog audio input port properties window in the LDC
Set up and customize the analog and digital audio streams. Select the desired source or destination port and
check the following settings / parameters:
Set a unique stream name;
▪
▪ Check the audio signal status;
▪ Check the enable/disable status of the stream;
▪ Set tags for the stream;
▪ In case of analog signal adjust the volume, balance, gain settings.

TIPS AND TRICKS: The stream names, tags, and device labels are searchable with the
41 41
Search Field.