Upgrade Firmware; Terminal Window - Lightware UBEX Series User Manual

 
     
8. Lightware Device Controller 8. Lightware Device Controller
8.17. Upgrade Firmware
Upgrade firmware window in the Settings menu
The centralized firmware upgrade method for the connected endpoint devices is the most comfortable way
to keep your devices up to date. The selected units can be updated together, the procedure is supervised
by the MMU, no user interaction is needed. During the firmware update, the AV transmission continues
smoothly in the unselected endpoint devices.

ATTENTION! The centralized firmware upgrade feature is working from the installed MMU firmware v1.1.0
and endpoint firmware v1.3.1 and available for the later firmware package versions. The endpoint firmware
packages till v1.3.1 can be installed with LDU2 software - see the details in the
Method section.
See the details about this feature and the steps of the upgrade in the
Upgrade section. #new
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Endpoint Upgrade - Manual
Endpoint Upgrade - Centralized Firmware
8.18. Terminal Window
Select the Settings / Terminal menu to open the Terminal window.
1
7
6
LW3 protocol help Pushing the button results a help window opening which describes the most
1
important information about LW3 protocol commands in HTML format.
Edit mode The default appearance is the read-only mode. If you want to modify the values
2
or parameters, tick the option. You will be prompted to confirm your selection.
3 Warning mode If this box checked in, a warning window pops up when you enable Edit mode.
4 Node list Correspondent parameters and nodes are shown which are connected to the
selected item in the protocol tree.
Manual button:
Set button:
Call button:
Protocol tree LW3 protocol tree; select an item to see its content.
5
Command line Type the desired command and execute it by the Send button. Clear all current
6
commands and responses in the Terminal window by the Clear button.

Terminal window

Commands and responses with time and date are listed in this window. Sent
7
command starts with '>' character, received response starts with '<' character.
The color of each item depends on the type of the command and response.
The content of the window can be emptied by the Clear button. If the Autoscroll
option is ticked, the list is scrolled automatically when a new line is added.
#terminal #advancedview
2 3
5
Manual (short description) of the node can be called and
displayed in the terminal window.
Saves the value/parameter typed in the textbox.
Calls the method, e.g. reloads factory default settings.
97 97
4