Add Tags To The Video Streams; Customize The Order Of The Endpoints; Set The Video Crosspoint State; Check The Signal Bandwidth Status - Lightware UBEX Series User Manual

 
     
3. Installation 3. Installation
3.9.7. Add Tags to the Video Streams
More tags can be attached to the streams and devices for the effective searchability.
Click on the source / destination port where the
stream is transmitted / received. Select the Stream
tab and find the Tags section and type a custom text
which can describe more streams well, for example:
Edited_by_Eric, and add it to the affected streams.

INFO: The following information are automatically added to the tags: stream name, device label, logical
device ID.
TIPS AND TRICKS:
The tags are searchable with the
3.9.8. Customize the Order of the Endpoints

INFO: You can find more details about the default port numbering in the
and the Streams section.
The default order of the endpoints is generated by the MMU based on the discovery order of the units -
independently of the operation mode. This order can be customized in the Device map tool.
Click on the Device map button, the tool opens in a new window. The order of the devices can be changed
easily using drag and drop method by the mouse. See more details about it in the
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
Search Field.
Default Naming of the Devices
Device map window
Device Map
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
3.9.9. Set the Video Crosspoint State
Set the connections between the
stream sources and the destination
ports.
Move the cursor of the mouse above
the desired crosspoint. You can check
your selection in the Highlighted Streams section. Click on the selected crosspoint to set up the connection.
3.9.10. Check the Signal Bandwidth Status
Check the signal bandwidth and the bandwidth limit status
indicator. When the bandwidth limit is exceeded, the source/
destination port tiles and the crosspoint tile appear as the
following:
Bandwidth Limitation
If an endpoint exceeds bandwidth limit, the MMU disable the stream of HDMI in 2 of the transmitter
automatically. The stream of HDMI in 1 is transmitted continuously.
Solution
More possible solutions can be applied to avoid the bandwidth limitation:
▪ Enable the scaler / FRC on the HDMI inputs of the transmitter;
Apply the color space conversion on the stream source(s).
▪
▪ In the case of 10 GbE link (only one SFP+ module / DAC cable is installed in the SFP+ ports) upgrade
the bandwidth performance of the endpoint to 20 GbE.
3.9.11. Set the HDCP Settings
Check the HDCP settings either on the sources and destinations. For more details about HDCP technology
see the HDCP Management
Click on the source port properties panels on
▪
the transmitter side and select the Port tab.
Check the HDCP enable setting. Put a tick to
enable HDCP capability on the port.
▪ Click on the destination port properties
panels on the receiver side and select the Port
tab. Check the HDCP mode setting.
INFO:
UBEX extenders always authenticate the
highest version of HDCP-encryption and cannot
force the lower version.
section.
Crosspoint
(connection) tile
section.
39 39
1/02
Source/destination
port tile