Audio Interface; Transmitter Mode - F100/R100 Models; Receiver Mode - F100/R100 Models; Transceiver Mode - F100/R100 Models - Lightware UBEX Series User Manual

 
     
4. UBEX Concept 4. UBEX Concept
4.5. Audio Interface
4.5.1. Transmitter Mode - F100/R100 Models
Port Diagram
The port diagram is valid for the
following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-R100
series
Description
The transmitter receives HDMI
audio signals via the two HDMI
input ports. The audio streams
are transmitted toward the remote endpoint device over the SFP+ links. The two source streams can be
selected to any output port on the destination side. The crosspoint settings are supervised by the MMU.
The HDMI output ports of the transmitter are HDMI loop-back ports and can be used as local HDMI outputs.
4.5.2. Receiver Mode - F100/R100 Models
Port Diagram
The port diagram is valid for the
following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-R100
series
Description
The receiver receives two HDMI
audio streams via the SFP+ links.
The streams can be selected to
any HDMI output ports, the crosspoint settings are available in the MMU.
The HDMI input ports of the receiver cannot accept audio signals due to software limitation.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Audio port diagram of the F100 transmitter
Audio port diagram of the F100 receiver
4.5.3. Transceiver Mode - F100/R100 Models
Port Diagram
The port diagram is valid for the following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-R100
series
Description
The transceiver receives one
HDMI audio stream via the SFP+
links and transmitting on the
HDMI out 1 port. The source signal
can be any audio streams from
the source side, the crosspoint
settings are supervised by the
MMU.
The transceiver receives an
HDMI audio signal via the HDMI
input 2 port. The audio stream
is transmitted toward the
destination side over the SFP+
links. The crosspoint settings are supervised by the MMU.
The local HDMI output port (HDMI out 2) is HDMI loop-back port and source is always the HDMI in 2 port.
The HDMI input 1 port of the transceiver cannot accept audio signals due to software limitation.
Audio port diagram of the F100 transceiver
52 52