R-Series Endpoints - Receiver Operation Mode - Lightware UBEX Series User Manual

 
     
3. Installation 3. Installation
3.4.5. R-series Endpoints - Receiver Operation Mode
2xMM-2xDUO and 2xSM-2xDUO
2xMM-QUAD and 2xSM-QUAD
2xSM-BiDi-DUO
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
HDMI out
Ethernet
Power
OPT DUO
OPT QUAD
OPT DUO
OPT QUAD
OPT BiDi DUO

WARNING! User Ethernet is also transmitted over the fiber optical interface so be sure not to create
network loop!
INFO:
The HDMI input ports cannot accept AV signals when the device is configured as receiver.
* You can find more information about the cabling between the switch the R-series endpoint devices in the
Connection between the Switch and R-series Endpoints
Connect the sink devices (e.g. monitor, projector) to the HDMI output 1 and
2 ports by HDMI cables.
Optionally connect the receiver to a LAN in order to control the device.
Connect the power adaptor to the AC input on the receiver first, then to the
AC power socket.
Connect the device and the L3 network switch by 2 pcs multimode Neutrik
opticalCON DUO or 4 pcs multimode LC fiber optical cables. *
Connect the device and the L3 network switch by a multimode Neutrik
opticalCON QUAD fiber optical cable. *
Connect the device and the L3 network switch by 2 pcs singlemode Neutrik
opticalCON DUO or 4 pcs singlemode LC fiber optical cables. *
Connect the device and the L3 network switch by a singlemode Neutrik
opticalCON QUAD fiber optical cable. *
Connect the device and the L3 network switch by a singlemode Neutrik
opticalCON DUO BiDi or 2 pcs singlemode LC fiber optical cables. * The
connector does not support the Neutrik opticalCON cross cable. Please use
standard cable only.
section.
31 31