Properties Windows - Audio Layer; Analog Audio Input Port; Analog Audio Output Port; Stream Switcher - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.7. Properties Windows - Audio Layer
6.7.1. Analog Audio Input Port
Clicking on the Analog in port icon of the transmitter, receiver, or
transceiver results opening the Port properties. The most important
signal and display information and settings are available on the panel:
Port properties window of the Analog in (TX)
Available settings and tools:
▪ Port naming;
▪ Volume: sets the input volume (attenuation) between 0%
(-95.62 dB) and 100% (0 dB). Clicking on the
the icon results +1% in the volume setting. The default value

is 100%.
Balance: sets the balance between -100 (total left) and 100 (total
▪
right). Clicking on the icon results -1, the

the balance setting. The default value is 0 (center).
▪ Gain: sets the gain between -12 dB and 35 dB. Clicking on the
icon results -1 dB, the icon results +1 dB in the gain setting.

The default value is 0 dB.
▪ Reloading factory default settings for the selected port.
#analogaudio #volume #balance #gain
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
6.7.2. Analog Audio Output Port
Clicking on the Analog out port icon of the transmitter, receiver, or
transceiver results opening the Port properties. The most important
signal and display information and settings are available on the panel:
Port properties window of the Analog out (RX)
Available settings and tools:
Port naming;
icon results -1%, ▪

▪ Volume: sets the input volume (attenuation) between 0%
(-95.62 dB) and 100% (0 dB). Clicking on the
the icon results +1% in the volume setting. The default value

is 100%.
icon results +1 in

▪ Balance: sets the balance between -100 (total left) and 100 (total
right). Clicking on the

the balance setting. The default value is 0 (center).
▪ Mute: enable or disable the muting of the output port.
▪ Reloading factory default settings for the selected port.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
6.7.3. Stream Switcher
icon results -1%,

icon results -1, the icon results +1 in
 
Clinking on the drop-down menu of the output port (any HDMI and
analog output ports) the source stream of the port can be selected.
The stream switcher drop-down menu of the HDMI out 1 (RX)
Four source streams are available for all output ports. The highlighted
one is the selected stream. The naming is the following: Stream #1..3;
and the IP address of the source device. #switch #crosspoint
Streams - TX-RX Pair
The Stream #1 and #2 are always the digital audio stream of the HDMI
in 1 and 2 ports of the transmitter. The Stream #3 is always the audio
stream of the analog audio input port of the transmitter or the receiver.
Streams - TRX-TRX Pair
The Stream #1 is always the digital audio stream of the HDMI in 2 port
of the transceiver, the Stream #2 is always the audio stream of the
analog audio input port of the transceiver.
64 64