Lightware UBEX Series User Manual page 71

 
     
8. Lightware Device Controller 8. Lightware Device Controller
Port Tiles
The port tiles and the colors of the displayed icons represent different states and information.
1 Port name
Tile icon
2 The icon can be changed under the Source/Destination properties window - Stream
information section (it is available by clicking on the
3 Hotplug state
Source/sink is connected.
Source/sink is not connected.
4 HDCP state
2.2
Signal is encrypted with HDCP 2.2.
1.4
Signal is encrypted with HDCP 1.4.
The sink device is not compatible with the current HDCP version.
Signal is not HDCP-encrypted.
Bandwidth of the stream
5
6 Resolution / refresh rate of the stream
Signal present indicator
7
If turquoise, signal is present, if grey, signal is not present.
8 Logical Device ID / Input/output port number
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Parameters button).
Connections Menu
Clicking on the  icon expands the Connections menu and more options and
settings become available.
Switch Modes
▪
Input Switch
▪
Output Switch
▪
View Mode
– Show Connected Only: when a source or destination stream is selected,
only the connected streams are displayed on the other panel.
Display Modes
▪ Show Inactive UBEXes: when enabled, the inactive devices are shown in the
crosspoint table. When it is disabled, the inactive devices are hidden.
▪ Show Disabled Streams: when enabled, the disabled streams are shown in the
crosspoint table. When it is disabled, the disabled streams are hidden.
Group by UBEXes: the streams belong to one endpoint device are framed with
▪
white.
▪ Audio Follows Video: The explanation of the two available options are the
following:
– Enabled: the audio stream follows the video stream when the video crosspoint
is changed. Beside of this the audio streams can be switched separately
from the video streams on the Audio crosspoint tab.
– Disabled: switching of a video stream does not effect the audio crosspoint
state.
▪ Auto VW layout activation: the explanation of the two available options are the
following:
– Enabled: the video wall layout becomes active suddenly when the crosspoint
setting is changed in it.
– Disabled: switching of a source stream does not effect the video wall
layout activation.
Connections
▪ Selected Port: the currently selected source or destination stream.
Connected Ports: the streams are listed which are connected to the selected
▪
source or destination stream.
71 71