Properties Windows - Audio Layer; Analog Audio Input Port; Analog Audio Output Port - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.7. Properties Windows - Audio Layer
6.7.1. Analog Audio Input Port
Clicking on the Analog in port icon of the transmitter, receiver, or transceiver results opening the Port
properties. The most important signal and display information and settings are available on the panel:
Port properties window of the Analog in (TX)
Available settings and tools:
▪ Port naming;
▪ Volume: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the icon results +1% in the volume setting. The default value is 100%.
 
▪ Balance: sets the balance between -100 (total left) and 100 (total right). Clicking on the
-1, the icon results +1 in the balance setting. The default value is 0 (center).

Gain: sets the gain between -12 dB and 35 dB. Clicking on the
▪
+1 dB in the gain setting. The default value is 0 dB.
▪ Reloading factory default settings for the selected port.
#analogaudio #volume #balance #gain
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
icon results

icon results -1 dB, the icon results
 
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
6.7.2. Analog Audio Output Port
Clicking on the Analog out port icon of the transmitter, receiver, or transceiver results opening the Port
properties. The most important signal and display information and settings are available on the panel:
Port properties window of the Analog out (RX)
Available settings and tools:
▪ Port naming;
▪ Volume: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the icon results +1% in the volume setting. The default value is 100%.
 
▪ Balance: sets the balance between -100 (total left) and 100 (total right). Clicking on the
-1, the icon results +1 in the balance setting. The default value is 0 (center).

▪ Mute: enable or disable the muting of the output port.
Reloading factory default settings for the selected port.
▪
82 82
icon results
