Hidden Usb Connector For Debug Purpose - Lightware UBEX Series User Manual

 
     
13. Assembly Guides 13. Assembly Guides
Step 5. Find the screw in the side of the jog dial knob and use a 1.3 mm hexagon (Allen) wrench key to fasten it.
Step 6. Place the rubber ring carefully to the jog dial knob.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
13.2. Hidden USB Connector for Debug Purpose
UBEX endpoints are built with a standard USB 2.0 mini B-type connector which is hidden under the jog dial
control knob.

ATTENTION! The USB connector is for debug purpose. Please use it only in case of the Lightware Support
requests it.
Follow the steps to reach the hidden USB connector:
Step 1. Remove the rubber ring from the jog dial knob.
Step 2. Find the screw in the side of the jog dial knob and use a hexagon (Allen) key wrench size 1.3mm to loosen it.
Step 3. Pull down the jog dial knob from the holder.
Step 4. The USB mini connector is available now.
The location of the hidden USB mini connector
181 181