Ethernet Interface; Serial Interface - Lightware UBEX Series User Manual

 
     
4. UBEX Concept 4. UBEX Concept
4.2.1. Ethernet Interface
Description
The endpoint devices and the Matrix Management Unit can be controlled over Ethernet interface. The ports
are standard RJ45 connectors in the case of endpoint and the MMU as well.

ATTENTION! When you connect to an endpoint, you reach the MMU from the control point of view. The
control commands and settings are done in the MMU finally.
The matrix can be configured with the following tools:
▪ Lightware Device Controller (LDC) software (details:
▪ LW3 protocol commands (details: Programmer's
Matrix Control over Ethernet - Example
The Concept
The matrix has one transmitter and one receiver connected to an L3 switch and supervised by the MMU.
There are four control devices connected to the network: a PC to the transmitter, a touch controller to the
receiver, a laptop to the switch, and a MacBook to the MMU. It does not matter which device you want to use
for controlling, all of them reach the MMU and you can configure the matrix.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Lightware Device Controller);
Reference).
4.2.2. Serial Interface
This section is about the serial interface of the MMU.

ATTENTION! The RS-232 port of the endpoint devices cannot be used for controlling the UBEX matrix.
Description
The Matrix Management Unit contains 2 pieces of 3-pole Phoenix connectors for serial communication. The
interface can be used for controlling the MMU or the matrix.
The matrix can be configured with the following tools:
▪ Lightware Device Controller (LDC) software (details:
▪ LW3 protocol commands (details: Programmer's
Matrix Control over RS-232 - Example
The Concept
The endpoint devices are connected to the UBEX matrix over the network switch via the optical ports. The
MMU is controlled by the system controller over the serial interface by LW3 protocol commands. All AV
related actions are available with LW3 protocol, e.g. crosspoint switching, EDID management, scaling, etc.
Lightware Device Controller);
Reference).
43 43