Lightware UBEX Series User Manual page 170

 
     
10. Firmware Upgrade 10. Firmware Upgrade
Step 2. Select the units for upgrading.
Pick the devices for upgrading. The selected lines will be highlighted in green.
The units are selected for upgrading
TIPS AND TRICKS:
If you are not sure which device is connected to your controller device directly, use
the Identify me feature clicking on the
seconds. The feature helps to identify the device itself in the rack shelf or on the desk.
Step 3. Check the upgrade parameters.
Click on the Parameters button to configure the
firmware upgrade.
Application Mode
The application mode (Extender or Matrix mode)
of the current UBEX system can be selected in
this section. Select the Matrix mode.
Click on the Apply button to save the settings.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
button. It makes the four front panel LEDs blink in green for 10

Parameters menu for the UBEX endpoints
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Step 4. Start the update and wait until it is finished.
Click on the Start Update button to start the procedure. The status is shown in percent in the right side of the
device line and the status of the all procedures in the lower light green progress bar.

ATTENTION! This upgrade is not backward compatible with the version running on some endpoints. After
upgrading these endpoints cannot be downgraded to versions prior to v1.4.0.

INFO: The devices might reboot several times during the firmware upgrade procedure.
Step 5. Wait until the units reboot with the new firmware.
Once the firmware upgrade procedure is completed, the units reboot with the new firmware.
Firmware upgrade is in progress
Firmware upgrade procedure is done
170 170