Audio Port Properties Windows; Hdmi Source / Hdmi Destination Port Properties Window; Analog Audio Source Port Properties Window - Lightware UBEX Series User Manual

 
     
8. Lightware Device Controller 8. Lightware Device Controller
8.10. Audio Port Properties Windows
8.10.1. HDMI Source / HDMI Destination Port Properties Window
Clicking on an HDMI audio source or destination port the properties panel opens on the right side. Clicking
on the icon the properties section opens in new window.
HDMI audio destination port properties window
The most important signal information is available on the panel.
Settings and Tools
▪
Stream naming;
▪ Enabled: when it is checked in, the stream is transmitted to the receiver; if it is not, the stream is muted.
▪ Disconnect stream (only for the destination streams): clicking on the button results the source stream
is disconnected from the output port.
▪ Tags: unique and configurable tags can be attached to the stream for the best identification. The tags
are searchable in the Search Field.
▪ Identify unit: Clicking on the button makes the four front panel LEDs blink in green for 10 seconds. The
feature helps to identify the device itself in the rack shelf or on the desk.
▪ Device properties: Clicking on the button opens the properties windows of the endpoint device.
▪ Restart unit: clicking on the button makes rebooting the device (the same as disconnecting from the
power source and reconnecting again).
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
#audio
8.10.2. Analog Audio Source Port Properties Window
Clicking on an analog audio source port the properties panel opens on the right side. Clicking on the
icon the properties section opens in new window.

Analog audio source port properties window

The most important signal information is available on the panel.
Settings and Tools
▪ Stream naming;
▪ Enabled: when it is checked in, the stream is transmitted to the receiver; if it is not, the stream is muted.
▪ Tags: unique and configurable tags can be attached to the stream for the best identification. The tags
are searchable in the Search Field.
▪ Volume: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the icon results +1% in the volume setting. The default value is 100%.
 
▪ Balance: sets the balance between -100 (total left) and 100 (total right). Clicking on the
-1, the icon results +1 in the balance setting. The default value is 0 (center).

▪ Gain: sets the gain between -12 dB and 35 dB. Clicking on the
+1 dB in the gain setting. The default value is 0 dB.
▪ Identify unit: Clicking on the button makes the four front panel LEDs blink in green for 10 seconds. The
feature helps to identify the device itself in the rack shelf or on the desk.
▪ Device properties: Clicking on the button opens the properties windows of the endpoint device.
▪ Restart unit: clicking on the button makes rebooting the device (the same as disconnecting from the
power source and reconnecting again).
78 78
#analogaudio #volume #balance #gain
icon results

icon results -1 dB, the icon results
 