Lightware UBEX Series User Manual page 83

 
     
8. Lightware Device Controller 8. Lightware Device Controller
Settings
▪ HDCP mode (Auto / Always); #hdcp
Power 5V mode (Auto / Always on / Always off);
▪
▪ Timing mode (Free run / Source locked);
▪ Identify Stream / Identify Display.
Scaler Settings (only for the HDMI out 1)
▪
Scaling mode:
– Passthrough: the scaler is in pass-through mode.
– Forced resolution: the scaling is active, the selected value in the forced resolution option will be
applied on the video signal;
– EDID based: the scaler forces the resolution which is read out from the EDID of the connected sink
device.
▪ Forced resolution: list of the available resolutions with refresh rate values. The selected one will be
applied on the video signal. See the available resolution in the
▪ EDID based resolution: the resolution which is read out from the EDID of the connected sink device.
▪ Image position (Stretch / Fit / Center);
▪ Color space conversion (No conversion / RGB / YUV 4:4:4 / YUV 4:2:2);
No Sync Screen (Test Pattern).
▪
Frame Rate Converter Settings (only for the HDMI out 2)
▪
Output resolution mode:
– Passthrough: the scaler is in pass-through mode.
– Forced resolution: the scaling is active, the selected value in the forced resolution option will be
applied on the video signal;
– EDID based: the scaler forces the resolution which is read out from the EDID of the connected sink
device.
Forced resolution: list of the available resolutions with refresh rate values. The selected one will be
▪
applied on the video signal. See the available resolution in the
▪ EDID based resolution: the resolution which is read out from the EDID of the connected sink device.
▪ Color space conversion (No conversion / RGB / YUV 4:4:4 / YUV 4:2:2);
▪ No Sync Screen (Test Pattern).
#scaler #frc #csc #colorspace #testpattern #nosyncscreen
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
#power5v
#timingmode #freerun #sourcelocked
#identifystream #identifydisplay
Resolutions of the Scaler / FRC
Resolutions of the Scaler / FRC
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Status / Signal Info
All important information (e.g. hotplug detect, HDCP status, resolution, total size, pixel clock, color space,
e.g.) are available in the status and signal info sections.
Display Info
All related information about the sink device connected to the output port.
Tools
▪ Frame Detector
rescaling / frame rate conversion.
SFP+ Link Panels
Clicking on the SFP+ Link 1 or 2 panel opens the properties of the SFP+ connections. The most important
signal information and the parameters of the SFP are available from the panel.
Link Aggregation Status Indicator
section.
Icon
SFP+ connection is established successfully and the link aggregation is working
successfully.
No connection is established between the SFP+ links.

INFO: You can find possible causes and solution suggestions in the
of no connection or link aggregation problems.
section.
- The tool displays the frame information of the transmitted stream after a possible
Description
Troubleshooting
83 83
#sfp
chapter in the case