Lod (Load) And Lodn (Load Not); Out (Output) And Outn (Output Not) - IDEC MICROSmart FC6A Series Ladder Programming Manual

4: B I
ASIC
Introduction
This chapter describes the basic instructions that perform sequence control.

LOD (Load) and LODN (Load Not)

The LOD instruction starts the logical operation with a NO (normally open) contact. The LODN instruction starts the logical
operation with a NC (normally closed) contact.
A total of eight LOD and/or LODN instructions can be programmed consecutively.
Valid Devices
Ladder Diagram
The valid device range depends on the FC6A Series MICROSmart type. For details, see "Device Addresses" on page
2-1.
Specify the bit by inserting a "." between the data register number and the bit position.

OUT (Output) and OUTN (Output Not)

The OUT instruction outputs the result of bit logical operation to the specified device. The OUTN instruction outputs the inverted
result of bit logical operation to the specified device.
Valid Devices
Ladder Diagram
The valid device range depends on the FC6A Series MICROSmart type. For details, see "Device Addresses" on page
2-1.
Specify the bit by inserting a "." between the data register number and the bit position.
Note: For restrictions on ladder programming of OUT and OUTN instructions, see "Restriction on Ladder Programming" on page 4-33.
NSTRUCTIONS
Instruction I
LOD 0-27
LODN 30-10597 30-10597
Instruction I
OUT
—
OUTN 30-10597
FC6A S MICROS
ERIES
Q M
0-17 0-7997
0-1999
10000-21247
Q M T
0-17 0-7997
—
10000-21247
L P
MART ADDER ROGRAMMING
T C R
0-511 0-225
C R
— —
M FC9Y-B1726
ANUAL
D P
0.0-7999.15
—
10000.15-61999.15
D P
0.0-7999.15
—
10000.15-61999.15
4-1