IDEC MICROSmart FC6A Series Ladder Programming Manual page 4

Regarding laws and compatible standards
This product adheres to the laws and compatible standards of all countries involved, as shown below.
European laws and standards
This product complies with the following EU directives.
Low Voltage Directive
•
RoHS Directive
•
RE Directive (FC6A-PC4 only)
•
To comply with these directives, this product has been designed and evaluated on the basis of the following international and
European standard.
IEC/EN 61131-2: 2007
•
EN50581:2012
•
EN301 489-1 V2.1.1& EN301 489-17 V2.1.1 (FC6A-PC4 only)
•
For details on the compatible standards and EU Directives, contact the distributor from which you purchased this product or visit our web site.
North America laws and standards
This product complies with the following standards.
*1
UL508
•
*1
UL61010-1
•
*1
UL61010-2-201
•
*1
CSA C22.2 No.142
•
*1
CSA C22.2 No.61010-1
•
CSA C22.2 No.61010-2-201
•
ANSI/ISA 12.12.01
•
CAN/CSA C22.2 No.213
•
*1 Certain FC6A Series MICROSmart models are not compatible. For details about applicable standards, please contact IDEC Corporation.
Chinese laws and standards
The FC6A-PC4 complies with the following certification.
SRRC
•
Marine standards
This product has been certified by the following classification societies.
(Applications have been submitted for certain models.)
ABS (American Bureau of Shipping)
•
DNV GL (Det Norske Veritas·Germanischer Lloyd)
•
LR (Lloyd's Register)
•
NK (Nippon Kaiji Kyokai)
•
* This product has not been certified for use on the bridge or deck.
For details on applicable standards and EU directives, please contact the dealer where purchased or check the IDEC website.
Under no circumstances shall IDEC Corporation be held liable or responsible for indirect or consequential damages resulting from
the use of or the application of IDEC PLC components, individually or in combination with other equipment.
All persons using these components must be willing to accept responsibility for choosing the correct component to suit their
application and for choosing an application appropriate for the component, individually or in combination with other equipment.
All diagrams and examples in this manual are for illustrative purposes only. In no way does including these diagrams and
examples in this manual constitute a guarantee as to their suitability for any specific application. To test and approve all
programs, prior to installation, is the responsibility of the end user.
Preface-3
*1
IMPORTANT INFORMATION
FC6A S MICROS
ERIES MART
L P M
ADDER ROGRAMMING ANUAL
FC9Y-B1726