IDEC MICROSmart FC6A Series Ladder Programming Manual page 325

Storage
Destination
Starting
Steady pulse frequency (high word)
number+10
Starting
Steady pulse frequency (low word)
number+11
Starting
Initial pulse frequency (high word)
number+12
Starting
Initial pulse frequency (low word)
number+13
Starting
— Reserved —
number+14
X axis
Starting
— Reserved —
number+15
Starting
Preset value (high word)
number+16
Starting
Preset value (low word)
number+17
Starting
Current value (high word)
number+18
Starting
Current value (low word)
number+19
Starting
Steady pulse frequency (high word)
number+20
Starting
Steady pulse frequency (low word)
number+21
Starting
Initial pulse frequency (high word)
number+22
Starting
Initial pulse frequency (low word)
number+23
Starting
— Reserved —
number+24
X axis
Starting
— Reserved —
number+25
Starting
Preset value (high word)
number+26
Starting
Preset value (low word)
number+27
Starting
Current value (high word)
number+28
Starting
Current value (low word)
number+29
*1 The upper and lower data registers change according to the 32-bit data storage method specified. For details, see "32-bit Data
Storage" on page 3-9.
*2 When the instruction input is turned on, the automatically calculated values are stored in the registers.
*3 The number of output pulses is stored in the data registers, regardless of the value of the absolute position counter.
(3) S2 (source 2): Initialization input
S2 specifies the initialization input.
When the initialization input is turned on, the initial values configured in the WindLDR RAMPL (Ramp Pulse Output with
Liner Interpolation) dialog box, on the Common Settings tab, are stored in the control registers. An external input or
an internal relay can be specified.
When the initialization input is on, the initial values are stored in the data registers with each scan. (Even when the RAMPL
instruction is not executed (when not on), if the initialization input is turned on, the initial values are stored in the data
registers.) To only initialize the values one time, use the initialization input in combination with the SOTU (single output up)
instruction or the SOTD (single output down) instruction.
Function
*1*2
*1*2
*1*2
*1
*1
*1
*1
*1*2
*1*2
*1*2
*1
*1
*1
*1
FC6A S MICROS L
ERIES MART
Setting
*1*2
15 to 100,000 (increments of 1 Hz)
15 to 100,000 (increments of 1 Hz)
Specify absolute position mode
-2,147,483,648 to 2,147,483,647
pulses
*3
1 to 100,000,000 pulses
*1*2
15 to 100,000 (increments of 1 Hz)
15 to 100,000 (increments of 1 Hz)
Specify absolute position mode
-2,147,483,648 to 2,147,483,647
pulses
*3
1 to 100,000,000 pulses
P M
ADDER ROGRAMMING ANUAL
18: P O
ULSE UTPUT
Reference
"(9) Steady pulse frequency" on
page 18-32
"(10) Initial pulse frequency" on
page 18-32
"(13) Preset value" on page 18-33
"(14) Current value" on page 18-33
"(13) Preset value" on page 18-33
"(14) Current value" on page 18-33
FC9Y-B1726
I
NSTRUCTIONS
18-29