IDEC MICROSmart FC6A Series Ladder Programming Manual page 98

4: B I
ASIC NSTRUCTIONS
Multiple OUT and OUTN
There is no limit to the number of OUT and OUTN instructions that can be programmed
into one rung.
Programming multiple outputs of the same output number is not recommended. However,
if doing so, it is good practice to separate the outputs with the JMP/JEND set of
instructions, or the MCS/MCR set of instructions. These instructions are detailed later in
this chapter.
When the same output number is programmed more than once within one scan, the
output nearest to the END instruction is given priority for outputting. In the example on the
right, output Q0 is off.
4-2 FC6A S MICROS L
ERIES MART
P M
ADDER ROGRAMMING ANUAL
Ladder Diagram
I1
Ladder Diagram
ON
I1
OFF
I2
OFF
I3
FC9Y-B1726
I2 Q0
Q1
Q2
Q0
OFF
Q0
END