IDEC MICROSmart FC6A Series Ladder Programming Manual page 231

[To indirectly specify the settings with data registers]
This example describes turning on output M0100 Monday to Friday each week from 8:30 to 17:15 as an example.
Select the Data register settings check box and set S1 to D0000 and S2 to M0000.
Parameter tab
Data register allocation
The settings on the P 1 tab are allocated to data registers D0 to D2 as shown in the table below. The settings configured on the
parameter tab are stored in D0 to D2 by turning on initialization input S2.
Data Register
D0
D1
D2
M8120
SOTU
M1
M8125
SOTU
M10
Setting
Day of the week setting
P 1 tab ON time
OFF time
WEEK S1 S2
D0 M0
MOV(W) S1 -
900
MOV(W) S1 -
1700
FC6A S MICROS
ERIES MART
11: W
15934 (Monday to Friday, both ON settings and OFF settings)
• The initialization input (M1) turns on with the first
scan and the initial settings configured on the P 1
M0
tab are stored in D0 to D2.
• The WEEK instruction starts operating according to
S3 D1
the values of data registers D0 to D2.
1 M100
• When M10 turns on, the ON time (D1) changes to
D1 - REP
9:00 and the OFF time (D2) changes to 17:00.
D1
• When M1 turns on, all of the WEEK instruction
D1 - REP
settings (D0 to D2) return to the initial settings.
D2
L P M
ADDER ROGRAMMING ANUAL
P
EEK ROGRAMMER
Initial Setting
830
1715
FC9Y-B1726
I
NSTRUCTIONS
11-15