IDEC MICROSmart FC6A Series Ladder Programming Manual page 506

26: S
CRIPT
Device List
This section shows the devices that can be used in Script Editor and the device notation.
This section describes available devices and its notation that can be used in the Script Editor dialog box.
Note: The device ranges differ depending on each FC6A Series MICROSmart. Specify the devices within the device range of the selected FC6A
Series MICROSmart. For device ranges, see "Device Addresses" on page 2-1.
I (Inputs)
I (Expansion inputs)
Q (Outputs)
Q (Expansion outputs)
M (Internal relays)
M (Special internal relays)
Bit device
R (Shift registers)
T (Timer contacts)
C (Counter contacts)
D (Data register bits)
D (Special data register bits)
D (Non-retentive data register bits)
D (Data registers)
D (Special data registers)
D (Non-retentive data registers)
Word device
TC (Timer current values)
TP (Timer preset values)
CC (Counter current values)
CP (Counter preset values)
Calculations in which both bit and word devices are used are not allowed.
Bit devices are always processed as bits, and values of those devices are 0 (OFF) or 1 (ON).
26-4
Device
FC6A S MICROS
ERIES MART
Notation in Script Editor
I0 to I27
I30 to I10597
Q0 to Q17
Q30 to Q10597
M0000 to M7997,
M10000 to M21247
M8000 to M9997
R000 to R255
C000 to C511
T000 to T1999
D0000.0 ... D0000.15 to D7999.0 ... D7999.15
D10000.0 ... D10000.15 to D61999.0 ... D61999.15
DD8000.0 ... D8000.15 to D8899.0 ... D8899.15
D70000.0 ... D70000.15 to D269999.0 ... D269999.15
D0000 to D7999
D10000 to D61999
D8000 to D8899
D70000 to D269999
TC000 to TC1999
TP000 to TP1999
CC000 to CC511
CP000 to CP511
L P M
ADDER ROGRAMMING ANUAL
FC9Y-B1726