IDEC MICROSmart FC6A Series Ladder Programming Manual page 256

12: D I
ISPLAY NSTRUCTIONS
Insert Bar Graph
The value of the specified device can be displayed as a bar graph on the HMI module LCD.
1.
2.
3.
4.
5.
6.
7.
1. Device
Enter the device to display as a bar graph.
Valid Devices
W (word) TC, TP, CC, CP, D
I (integer) D
D (double word) CC, CP, D
L (long) D
F (float) —
2. Data Type
Selects the data type for the specified device.
Data Type
W (word)
I (integer)
D (double word)
L (long)
F (float)
For data types, see "Data Types for Advanced Instructions" on page 3-7.
3. Maximum
Enter the maximum value for the bar graph. If the device value is larger than the maximum value, the bar graph is displayed as
the maximum value. The valid range varies based on the data type. For data types, see "Data Types for Advanced Instructions"
on page 3-7
.
4. Minimum
Enter the minimum value for the bar graph. If the device value is smaller than the minimum value, the bar graph is displayed as
the minimum value. The valid range varies based on the data type. For data types, see "Data Types for Advanced Instructions"
on page 3-7
.
5. Origin
Enter the value to be the origin of the bar graph. If the device value is larger than the origin value, the bar graph is displayed on
the right side of the origin value. If the device value is smaller than the origin value, the bar graph is displayed on the left side
of the origin value. The valid range varies based on the data type. For data types, see "Data Types for Advanced Instructions" on
page 3-7 The origin value must satisfy the condition of Minimum ≤ Origin ≤ Maximum.
.
Line A monitor
Target count: 30000
Prod. count: 14500
6. Occupied Area
The occupied area is determined by the selected range on the LCD display area (or work area). If multiple rows are selected, the
area at the top line in the selected range is used (rows: 1, columns: 1 to 24).
12-8
X
X
X
X
—
Min ≤ Origin ≤
FC6A S MICROS
ERIES MART
Max
L P M
ADDER ROGRAMMING ANUAL
FC9Y-B1726