Hyundai HL955 Manual page 84

Fault code
J1939 SPN
J1939 FMI
Fuel pump pressurizing assembly 1 circuit -
272
Voltage above normal, or shorted to high
1347
source. High signal voltage or open circuit
3
detected at the fuel pump actuator circuit.
SAE J1939 multiplexing PGN timeout error -
285 Abnormal update rate. The ECM expected
639 information from a multiplexed device but did
9 not receive it soon enough or did not receive it
at all.
SAE J1939 multiplexing configuration error -
286
Out of calibration. The ECM expected
639
information from a multiplexed device but only
13
received a portion of the necessary information.
Sae J1939 multiplexing remote accelerator
288 pedal or lever position sensor circuit - Received
974 network data in error. The oem vehicle
19 electronic control unit (VECM) detected a fault
with the remote accelerator.
295 Barometric pressure - Data erratic, intermittent,
108 or incorrect. An error in the barometric pressure
2 sensor signal was detected by the ECM.
Injector solenoid driver cylinder 1 circuit -
322
Current below normal, or open circuit.
651
Current detected at injector 1 when voltage is
5
turned OFF.
Injector solenoid driver cylinder 5 circuit -
323
Current below normal, or open circuit.
655
Current detected at injector 5 when voltage is
5
turned OFF.
Injector solenoid driver cylinder 3 circuit -
324
Current below normal, or open circuit.
653
Current detected at injector 3 when voltage is
5
turned OFF.
Injector solenoid driver cylinder 6 circuit -
325
Current below normal, or open circuit.
656
Current detected at injector 6 when voltage is
5
turned OFF.
Injector solenoid driver cylinder 2 circuit -
331
Current below normal, or open circuit.
652
Current detected at injector 2 when voltage is
5
turned OFF.
Injector solenoid driver cylinder 4 circuit -
332
Current below normal, or open circuit.
654
Current detected at injector 4 when voltage is
5
turned OFF.
Engine coolant temperature - Data erratic,
334
intermittent, or incorrect. The engine coolant
110
temperature sensor is reading an erratic value
2
at initial key ON.
※ Some fault codes are not applied to this machine.
Reason
3-28
Effect (only when fault code is active)
Engine may run rough, may stop running, may
not start, or may be difficult to start.
At least one multiplexed device will not operate
properly.
At least one multiplexed device will not operate
properly.
Remote accelerator will not operate.
Engine power derate.
Engine power derate.
The current to the injector is shut OFF.
Engine power derate.
The current to the injector is shut OFF.
Engine power derate.
The current to the injector is shut OFF.
Engine power derate.
The current to the injector is shut OFF.
Engine power derate.
The current to the injector is shut OFF.
Engine power derate.
None on performance.