Hyundai HL955 Manual page 242

(2) (2) Oil pressure pump Oil pressure pump
①
Insert pressure relief valve (1) into the
housing hole until contact is obtained.
Mount two adjusting screws (S) and
place gasket (2) and oil feed housing (3).
※
Use assembly grease.
Adjusting screws (M8)
②
Install two adjusting screws (S) and
mount stator shaft (1).
※
Pay attention to radial installation
position.
Adjusting screws (M10)
※
In case of wear marks in the pump
housing or on the control disk, the pump
assy must be replaced.
③
Install outer rotor.
※
C h a m f e r ( s e e a r r o w ) t o s h o w
downwards.
④
Install inner rotor.
※
Teeth (see arrow) to show upwards.
5870 204 011
5870 204 007
3-186
1
S
1
S
1
2
S
7609ATM350
7609ATM351
7609ATM352
7609ATM353