Hyundai HL955 Manual page 251

⑨
Install the single parts according to figure
TM378.
※
Preload the compression springs of the
follow-on slides and fasten the pistons
preliminarily by means of cylindrical pins
Ø
(S) 5.0 mm (assembly aid), see arrows
(S).
Install two adjusting screws.
Adjusting screws M5
Assemble flat gasket (1) and housing
cover. Then place the housing cover by
means of adjusting screws equally until
contact.
⑩
Preload the pistons with Torx screws and
remove the cyl. pins (assembly aid)
again.
Then fasten the housing cover by means
of Torx screws (1).
·Tightening torque (M5/10.9×30) :
0.56 kgf·m (4.06 lbf·ft)
Adjusting screws
Reducer
Socket spanner TX-27
⑪
Mount the pressure regulators with O-ring
13.5 × 2 (1) and fasten them by means of
fixing plates and cap screws.
※
Install the fixing plate with the neck
showing downwards.
Observe radial installation position of the
pressure regulators, see figure.
·Tightening torque (M5/8.8×12) :
0.56 kgf·m (4.06 lbf·ft)
⑫
Assemble the wiring harness (1) and
connect the pressure regulators (6EA).
※
See figure TM368 for installation position
of pressure regulators.
※
Pay attention to the installation position of
the wiring harness, also see markings
(figure TM009).
5870 204 036
5870 204 036
5870 656 056
5873 042 002
3-195
1
1
1
S
7609ATM379
7609ATM380
7609ATM381
1
7609ATM382