Hyundai HL955 Manual page 304

1 Planetary carrier
2 Output shaft
X Gap width
22
Select the cover (optional) on the basis
of the following table.
Determined gap Offset to be used
width (Delta) on the cover
0.13 ± 0.01 mm ZGAQ-04137
0.30~0.24 mm
0.239~0.18 mm 0.07 ± 0.01 mm ZGAQ-04370
0.179~0.10 mm 0.0 mm
※
Cover ( ZGAQ-04370
0.07 mm on one side and an offset of
0.13 mm on the other side.
※
Offset 0.13 mm is visually marked with an
annular groove (see arrow).
23
Insert the cover with the offset e.g.
0.07 mm showing to the planetary carrier
and tighten with new new locking screws.
※
When using the cover with offset
0.07 mm, the groove (figure AX167) must
be visible when the cover is installed.
※
Tighten locking screws successively with
a tightening torque of 20.4 kgf·m (148
lbf·ft).
Then retighten the locking screws
successively with a tightening torque of
51 kgf·m (369 lbf·ft).
24
Install O-ring (see arrow 1) to the cover.
Then wet contact face (arrow 2).
※
Use new cover and O-ring.
P/No.
ZGAQ-03909
) has an offset of
3-248
1
7609AAX166
7609AAX167
7609AAX168
2
7609AAX169