Hyundai HL955 Manual page 339

18
Roll input pinion over crown wheel in
both directions (coast - drive flank
meshing - contact pattern).
※
Special tool
Clamping fork
19 Disassemble differential.
Compare contact pattern to examples –
page 3-285.
※
If contact pattern differs considerably,
use a suitable shim for correction (see
figure 7577AAXR085, page 3-278).
20 If disassembled :
Insert shim(s) (2) into sun gear shaft (1)
and mount stub shaft (3).
※
If position was not allocated, as specified
in disassembly instructions on page
3-277, figure 7577AAXR072 and sun
gear shaft clearance (see page 3-268,
figure 7577AAXR58~62) must be set on
both output sides.
21 Insert preassembled stub shafts into
both outputs (considering allocation to
the correct output side).
5870 240 025
3-283
7577AAXR099
7577AAXR100
2
3
7577AAXR101
7577AAXR102
1