Hyundai HL955 Manual page 290

⑦
Heat the tapered roller bearing and insert
it into the input pinion until contact is
obtained.
Setting of rolling torque of input pinion Setting of rolling torque of input pinion
bearing 0.15~0.41 bearing 0.15~0.41 kgf kgf·m m (1.11~2.95
(without shaft seal) (without shaft seal)
⑧
Insert spacer (e.g. s = 8.18 mm).
※
According to our exper ience the
necessary rolling torque is obtained
when reusing the spacer which has been
removed during disassembly (e.g. s =
8.18 mm).
A later check of the rolling torque,
however, is absolutely necessary.
⑨
Insert the preassembled input pinion into
the axle drive housing and insert the
heated tapered roller bearing until
contact is obtained.
⑩
Press the protection plate onto the input
flange (see arrow) until contact is
obtained.
※
Do not fit the shaft seal until the contact
pattern has been checked.
(1.11~2.95 lbf lbf·ft ft)
3-234
7609AAX117
7609AAX118
7609AAX119
7609AAX120