Hyundai HL955 Manual page 459

(8) Remove bolt (19), washer (20) and then
take out cover (2) and shims (4, 5).
(9) Take out dust seal (13) from the cover (2).
(10) Remove the bearing (1), and dust seal
(13).
(11) Remove bolt (19), washer (20) and then
take out cover (17, 18) and shims (4, 5).
(12) Take out the dust seal (12) from the cover
(17, 18).
(13) Remove the bearing (1) and collar (8).
3) 3) INSPECTION INSPECTION
(1) Check the bearing sliding surface for excessive wear, scorching or scratches; replace if
necessary.
(2) Replace all dust seals (12,13) with new ones.
Grind any pins (7, 11) dented with an oilstone or replace any pins abrasive excessively.
(3)
(4) Check inside cover (2, 3, 17, 18) and collar (8, 9) for dents or scratches; if any damage is found,
correct with a grinder or replace.
The serviceable limit of pins and bushings is shown in the table below.
(5)
Item No. Name
7, 11 Pin
1 Tapered roller bearing
8, 9 Collar
12, 13 Dust seal
UPPER
LOWER
Std
dimension
Outer dia
74.5
75
When removed
5-55
19,20
2
13
13
19,20
8 12 17
1 12 18
Serviceable limit
Inner dia Clearance
75.5
0.8
75.5
4,5
29 29
1
75795SE16
4,5
29
75795SE19
Unit : mm
Remedy
Replace
Replace