Hyundai HL955 Manual page 310

(1) Disassembly output assy/brake :
For any replacement of components you
can remove the output assy (with brake)
as one unit.
- In this context refer to work steps on
page 3-255~264.
- F i g u r e 7 5 7 7 A A X R 0 0 7 ~ 0 0 9 a n d
assembly steps on page 3-268~272.
Please consider, however, that multi discs Please consider, however, that multi discs
of the brake must be replaced on both of the brake must be replaced on both
outputs each. outputs each.
(2) (2) Replacement combi seal ring (output) : Replacement combi seal ring (output) :
The combi seal ring (output) can also
be replaced on the installed axle - for
this purpose remove output shaft.
※
For the installation of the combi seal ring -
refer to work steps on page 3-261 figure
7577AAXR030~032.
※
Special tool
Pry bar
(3) (3) Output/brake : Output/brake :
①
Disassemble brake tube.
②
Take up output by means of a lifting
bracket.
Loosen bolted connection (output/axle
housing) and separate output from axle
housing.
※
Pay attention to releasing end plate and
multi-discs.
※
Special tool
Lifting bracket
5870 345 071
5870 281 043
3-254
7577AAXR005
7577AAXR006
7577AAXR007
7577AAXR008