Hyundai HL955 Manual page 392

(5) Use a suitable pipe to mount the shaft
seal, but don't push it too deep. If the shaft
ring touches the bearing ring you will
damage the seal ring.
(6) Assemble the circlip.
(7) Assemble the circlip in the correct
position.
※
This discription showes how th change This discription showes how th change
the drive shaft seal but it isn't the way the drive shaft seal but it isn't the way
of serial assembly. of serial assembly.
The seal is assembled together with the The seal is assembled together with the
taper roller bearing from inside the taper roller bearing from inside the
motor housing normally to get a secure motor housing normally to get a secure
sealing condition. If you decide to repair sealing condition. If you decide to repair
the motor in the shown way be very the motor in the shown way be very
careful while handling so that the drive careful while handling so that the drive
shaft wouldn't be damaged during shaft wouldn't be damaged during
disassembly of the shaft seal. disassembly of the shaft seal.
4-49
7609A4BS35
7609A4BS36
7609A4BS37