Hyundai HL955 Manual page 105

Table of Contents

Advertisement

Fault code
J1939 SPN
J1939 FMI
3714
Engine protection torque derate - Condition
1569
exists. Critical fault codes related to engine
31
operation are active.
Engine speed at idle - Data valid but below
3715
normal operating range - Moderately severe
188
level. The engine speed at idle has exceeded
16
the governed idle speed.
Engine speed at idle - Data valid but below
3716
normal operational range - Moderately severe
188
level. Engine is not maintaining the governed
18
idle speed.
Aftertreatment outlet NOx sensor - Out of
3717
calibration. A calibration mismatch between the
3226
aftertreatment outlet NOx sensor and the ECM
13
has been detected.
Aftertreatment intake NOx - Out of calibration. A
3718
c a l i b r a t i o n m i s m a t c h b e t w e e n t h e
3216
aftertreatment intake NOx sensor and the ECM
13
has been detected.
Battery 1 voltage - Data valid but below normal
3724
operating range - Least severe level.
168
Low voltage to the EGR valve device driver has
17
been detected.
3725
Aftertreatment Intake NOx sensor - Abnormal
3216
rate of change. The aftertreatment intake NOx
10
sensor reading is not valid.
High pressure common rail fuel pressure relief
3727
valve - Mechanical system not responding or
5571
out of adjustment. The fuel rail high-pressure
7
relief valve has opened at a lower than
expected pressure.
Engine starter mode overcrank protection -
3737
Condition exists. The starter motor has been
1675
temporarily disabled in order to prevent starter
31
damage.
High pressure common rail fuel pressure relief
3741
valve - Data valid but above normal operational
5571
range - Most severe level. The fuel rail pressure
0
relief valve has opened due to high fuel rail
pressure.
3749
Aftertreatment outlet NOx sensor - Data not
3226
rational - Drifted high. An offset in the outlet
20
NOx sensor reading has been detected.
3838
Estimated engine parasitic losses - Percent
2978
torque - Abnormal update rate. A loss of
9
communication has been detected.
Cruise control disable command - Abnormal
3843
update rate. No communication or an invalid
5603
data transfer rate has been detected on the
9
J1939 data link between the ECM and the
cruise control.
※ Some fault codes are not applied to this machine.
Reason
3-49
Effect (only when fault code is active)
Possible reduced engine performance.
Possible reduced engine performance.
None on performance.
None on performance.
None on performance.
Possible reduced engine performance.
None on performance.
Possible reduced engine performance.
Starter operation is prohibited until the starter
motor has adequately cooled.
Engine may run rough, may stop running, may
not start, or may be difficult to start.
None on performance.
None on performance.
None on performance.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hl955tm

Table of Contents