Hyundai HL955 Manual page 243

⑤
Place control disk and fix it radially by
means of two cylindrical screws M6×12
(1).
※
Do not tighten the cylindrical screws -
just turn them in until contact is obtained
and then turn them back by approx. 1/2
rotation.
※
Pay attention to the installation position
of the control disk, see figure.
Place O-ring 182×3 (2) into the annular
groove and oil it.
⑥
With the sealing lip showing downwards,
carefully insert the shaft seal 75×905×
10 (1) into the pump housing (2) until
contact is obtained.
※
Wet outer diameter of shaft seal with
spirit.
Driver
Handle
※
Oil sliding bearing (see arrow) before the
assembly.
⑦
Mount inner installer (S) onto the stator
shaft.
Mount preassembled transmission pump
(1).
※
Pay attention to radial installation
position.
Inner installer
⑧
Mount preassembled pump with driver
(S1) until contact is obtained.
Assembly fixture (S＋S1) 5870 345 126
(Inner installer and driver)
5870 055 070
5870 260 002
see figure TM357
3-187
1
S
S1
7609ATM354
1
2
7609ATM355
1
7609ATM356
7609ATM357