Hyundai HL955 Manual page 298

(8) (8) Reassembly output and brake Reassembly output and brake
①
Pull in wheel stud into the output shaft
until contact is obtained.
Wheel stud puller-basic tool
Insert (M22 × 1.5)
Special tool may only be used for repair
solution when exchanging individual
wheel studs with mounted output shaft.
When using a new output shaft, mount
the wheel studs with the press.
②
Heat tapered roller bearing and insert it
into the output shaft until contact is
obtained.
③
Wet O-ring of slide ring seal and locating
hole with spirit.
Snap new new slide ring seal (part 1) into the
output shaft.
Then mount new new slide ring seal (part 2)
accordingly into the brake housing.
※
For the installation position of the seal
please also refer to sketch, page 3-244.
※
The surface of the slide ring seal may not
have any grooves, scratches or other
types of damage.
Take care that the sealing surface is
parallel to the housing face.
The O-rings must be mounted evenly
into the locating hole and must not bulge
out of the hole.
R i s k o f i n j u r y - M e t a l r i n g s h ave R i s k o f i n j u r y - M e t a l r i n g s h ave
extremely sharp edges. extremely sharp edges.
Wear protective gloves. Wear protective gloves.
5870 610 001
5870 610 002
3-242
7609AAX143
7609AAX144
7609AAX145
7609AAX146