Hyundai HL955 Manual page 229

9) 9) INSTALLATION OF INPUT SHAFT, OUT- INSTALLATION OF INPUT SHAFT, OUT-
PUT SHAFT, PUMP SHAFT (POWER- PUT SHAFT, PUMP SHAFT (POWER-
TAKE OFF SHAFT) AND CLUTCHES TAKE OFF SHAFT) AND CLUTCHES
(1) If the suction tube (1) in the housing front
part is to be replaced, it is imperative to
use the special tool (rolling tool) for
a s s e m bl y. T h e n f i x t h e t u b e w i t h
cylindrical screw (2). (Oil cylindrical screw)
※
It is always necessar y to use new
cylindrical screws.
·Tightening torque (M8/8.8×12) :
2.34 kgf·m (17.0 lbf·ft)
Rolling tool
Lubricant
※
The spare parts service supplies the lubri-
cating oil tube (1) only as a complete
package with the housing front part.
※
Single parts delivery upon request only.
※
Assembly is only possible with the spe-
cial tool.
Rolling tool
Lubricant
(2) Mount O-rings 22×3 into the annular
groove of the oil tubes (1 and 2) and oil
them.
Then insert tubes into the housing front
part, oil cylindrical screws (3 and 4) and
fix them.
※
It is always necessary to use new cylindri-
cal screws.
·Tightening torque (M8/8.8×12) :
2.34 kgf·m (17.0 lbf·ft)
·Tightening torque (M8/8.8×50) :
2.34 kgf·m (17.0 lbf·ft)
5870 600 003
5870 451 006
5870 600 005
5870 451 006
3
1
4
3-173
1
2
1
7609ATM306
7609ATM307
3
2
4
7609ATM308