Hyundai HL955 Manual page 303

18
Wet front face (contact face bearing
inner ring, arrow 1) and profile (teeth,
arrow 2) in the output shaft with anti-
corrosive agent.
19 Align disk package centrally and radially.
Then insert the planetary carrier by
means of the lifting device into the teeth
of the output shaft.
Rear axle
(planetary carrier with 3 planetary gears)
Inner extractor
Eye bolt
Front axle
(planetary carrier with 4 planetary gears)
Inner extractor
Eye nut
Setting of gap width output shaft / Setting of gap width output shaft /
planetary carrier planetary carrier
20
Bring planetary carrier with measuring
disk and three old locking screws, which
were removed during disassembly, into
contact position.
·Tightening torque :
20.4 kgf·m (148 lbf·ft)
Measuring disk
21
Pivot output 180˚ and measure gap
width from the output shaft to the
planetary carrier (see also subsequent
sketch).
Gap width e.g. . . . . . . . . . . . . . . . 0.21 mm
Then remove the locking screws and the
measuring disk again.
5870 300 019
5870 204 073
5870 300 017
5870 204 076
AA00 360 730
3-247
7609AAX162
7609AAX163
7609AAX164
7609AAX165