Hyundai HL955 Manual page 372

1
2
3
4
1 Counter nut
2 Adjusting screw
3 Lining pad
⑦
Release the counter nut (1) and unscrew the adjusting screw (2) from the brake housing.
※
The lining spring (5) is pre-tensioned. The lining spring (5) must be held in position with a The lining spring (5) is pre-tensioned. The lining spring (5) must be held in position with a
suitable tool whilst removing the adjusting screw (2). suitable tool whilst removing the adjusting screw (2).
⑧
Remove the lining spring (5).
⑨
Remove the two lining pads (3, 4) from the lining compartment in the brake housing.
※
If there is no possibility of changing the brake lining carriers (3, 4) as described above (not If there is no possibility of changing the brake lining carriers (3, 4) as described above (not
enough space), the brake must be removed completely. The procedure for removing the enough space), the brake must be removed completely. The procedure for removing the
brake from the gearbox can be taken from the fitting instructions. Refer to page 3-93. brake from the gearbox can be taken from the fitting instructions. Refer to page 3-93.
※
Check the pressure line. A pressure line which is too short must be unscrewed in order to Check the pressure line. A pressure line which is too short must be unscrewed in order to
permit removal of the brake. permit removal of the brake.
An emergency release of the parking brake must be carried out before releasing the An emergency release of the parking brake must be carried out before releasing the
pressure line. pressure line.
⑩
Replace the lining pads (3, 4).
⑪
The lining spring (5) must be pushed in position with a suitable tool whilst screwing in the
adjusting screw (2).
※
If you removed the brake completely because of a lack of space you must carry out fitting If you removed the brake completely because of a lack of space you must carry out fitting
of the brake in accordance with the fitting instructions. Refer to page 3-171. of the brake in accordance with the fitting instructions. Refer to page 3-171.
※
After changing the lining pads (3, 4), or repair to them, the brake must be adjusted in After changing the lining pads (3, 4), or repair to them, the brake must be adjusted in
accordance with 3) accordance with 3) FITTING AND SETTING INSTRUCTION FITTING AND SETTING INSTRUCTION.
4-29
4 Lining pad
5 Lining spring
5
7609A4BS25